Connect Cables

This section explains how to wire a USB cable or external drawer cable when a tablet, barcode reader, or external drawer is connected.

Please perform the steps below when the power of the device is turned off.

  • The cable outlet is located in two locations, to the right and left.
    Wire the USB cable according to the position of mPOP.
  • Wire it so it goes underneath or between the USB cable hook and pull it out through the outlet.


  • Wiring example 1

    Wiring example 2

Note

  • Make sure the cables are properly inserted in the cable hook so that mPOP does not tilt when it is set up.
  • A USB cable for the tablet is not included in the accessories. Use a commercially available USB cable (or one that came with the tablet).